Parking Brake

Inspection On Vehicle

~1min read

INSPECTION ON VEHICLE

PROCEDURE

1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other components to be operated without removing parts. This non-intrusive functional check can be very useful, since intermittent operation can be identified before parts or wiring are moved. Performing the Active Tests at the start of troubleshooting saves time during diagnosis. Data List information can be displayed during Active Tests.

(a) Connect the Techstream to the DLC3 with the ignition switch OFF.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Chassis / ABS/VSC/TRC/EPB / Active Test.

(e) When the vehicle tires are lifted off the ground and the Techstream is used to operate the electric parking brake, check the condition of the rear tires.

(f) Perform the Active Test following the instructions on the tester.

Chassis > ABS/VSC/TRAC/EPB > Active Test

PKB Lock Control

Chassis > ABS/VSC/TRAC/EPB > Active Test

PKB Release Control

If the result is not as specified, inspect the electric parking brake actuator.

Click here

(g) Turn the ignition switch ON, operate the electric parking brake switch on the lock side for 1 second, and make sure that the parking brake indicator light (red) comes on.

(h) Also make sure that the brake warning light / yellow (minor malfunction) does not come on at the same time.