Removal
REMOVAL
PRECAUTION / NOTICE / HINT
NOTICE:
- Immediately after installing the brake pads, braking performance may be reduced. Always perform a road test in a safe area, paying attention to the surroundings.
- After replacing the front disc brake pads, always perform a road test to check brake effectiveness and whether there is any vibration.
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. REMOVE FRONT WHEEL
Click here
![]()
2. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto a painted surface, wipe it off immediately.
3. DISCONNECT FRONT BRAKE HOSE
(a) Remove the union bolt and gasket, and disconnect the front brake hose from the front disc brake cylinder assembly. |
![]() |
4. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY
(a) Hold the 2 front disc brake cylinder slide pins, then remove the 2 bolts and the front disc brake cylinder assembly. |
|
5. REMOVE FRONT DISC BRAKE PAD
(a) Remove the 2 front disc brake pads from the front disc brake cylinder bracket. |
![]() |
6. REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
Click here![]()
7. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
(a) Remove the 4 front disc brake pad support plates from the front disc brake caliper support. NOTICE: Each front disc brake pad support plate has a different shape. Be sure to make identification marks on each front disc brake pad support plate so they can be reinstalled in their original positions. |
![]() |
8. REMOVE FRONT DISC BRAKE CALIPER GUIDE PIN
(a) Remove the 2 front disc brake caliper guide pins from the front disc brake caliper support. |
![]() |
(b) Using a screwdriver with the tip wrapped in masking tape, remove the front disc brake caliper guide pin bushing from the front disc brake caliper guide pin (lower side). NOTICE: Do not damage the front disc brake caliper guide pin. |
|
9. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT
(a) Remove the 2 front disc brake bushing dust boots from the front disc brake caliper support. |
![]() |
10. REMOVE FRONT DISC BRAKE CALIPER SUPPORT
(a) Remove the 2 bolts and the front disc brake caliper support from the steering knuckle. |
![]() |
11. REMOVE FRONT DISC
(a) Make alignment marks on the front disc and the front axle hub assembly. HINT: If the front disc is to be replaced, alignment marks are not necessary. |
|
(b) Remove the front disc.








