Inspection
INSPECTION
PROCEDURE
1. INSPECT BRAKE CALIPER AND PISTON
(a) Check the front disc brake caliper cylinder bore and the front disc brake piston for rust or scratches. If necessary, replace the front disc brake caliper assembly and the front disc brake piston.
2. INSPECT BRAKE PAD LINING THICKNESS
(a) Using a ruler, measure the thickness of the front disc brake pad lining. Standard thickness: 12.2 mm (0.480 in) Minimum thickness: 1.0 mm (0.0394 in.) HINT:
|
|
3. INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE
(a) Make sure the front disc brake pad support plates have sufficient rebound, are not deformed, cracked or worn, and are free of rust and dirt. If necessary, replace the front disc brake pad support plates.
(b) Before installing the front disc brake pad support plates on the front disc brake caliper support, clean the mounting surface of the caliper support using brake cleaner.
(c) Install the front disc brake pad support plates, and make sure there is no play or deformation.
(d) Before installing the front disc brake pads, make sure the brake pad support plates have spring tension.
(e) Install the brake pads and make sure they do not come loose easily.
4. INSPECT DISC THICKNESS
(a) Using a micrometer, measure the thickness of the front disc. Standard thickness: 28.0 mm (1.10 in) Minimum thickness: 25 mm (0.984 in) HINT: If the front disc thickness is less than the minimum thickness, replace the front disc. |
|
5. INSPECT DISC RUNOUT
(a) Check the front wheel hub bearing for play and the front axle hub for runout.
Click here![]()
(b) Align the alignment marks on the front disc and the front axle hub, then temporarily install the front disc using the 5 hub nuts.
Torque:
103 N·m {1 050 kgf·cm, 76 ft·lbf}
(c) Using a dial indicator, measure the disc runout at 10 mm (0.394 in) from the outer edge of the front disc. Maximum disc runout: 0.05 mm (0.00196 in) NOTICE: Keep the dial indicator magnet away from the front speed sensor. HINT: If the runout is greater than the maximum, change the installation position of the front disc to minimize the runout. If the runout is still greater than the maximum after changing the installation position, resurface the front disc. If the front disc thickness is less than the minimum, replace the front disc. |
|
(d) Remove the 5 hub nuts and the front disc.


