Supplemental Restraint Systems

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the entire front seat airbag assembly are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

CAUTION:

  • Be sure to read the Precautions carefully before performing maintenance.

    Click here

  • Wear protective gloves. Sharp edges on parts may cause injury to your hands.

NOTICE:

If a front seat airbag assembly has deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate-type front seatback pad and separate-type front seatback cover with the necessary parts, depending on the damage caused by the collision.

HINT:

  • Perform the same procedure for the driver side and front passenger side.
  • The procedure below applies to the driver side.

PROCEDURE

1. REMOVE FRONT SEAT BACK SEPARATE TYPE COVER WITH PAD

Click here

2. REMOVE FRONT SEAT AIRBAG ASSEMBLY

CAUTION:

When storing the front seat airbag assembly, make sure the deployment side is facing up.

Deployment side

(a) Release the latch.

(b) Remove the 2 nuts and the front seat airbag assembly.

NOTICE:

  • Do not reuse the nuts.
  • Make sure the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.