Supplemental Restraint Systems

Removal

~3min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during curtain airbag assembly removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. PRECAUTIONS

CAUTION:

Be sure to read the Precautions carefully before performing maintenance.

Click here

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL

Click here

CAUTION:

  • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  • If any Supplemental Restraint System (SRS) component is accidentally deployed, serious injury may result.

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

3. REMOVE ROOF HEADLINING ASSEMBLY

Click here

4. REMOVE CURTAIN AIRBAG ASSEMBLY

CAUTION:

When registering the curtain airbag assembly, make sure the airbag deployment side faces upward.

Deployment side

NOTICE:

When removing the curtain airbag assembly, ask for help holding it to prevent it from bending.

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Using a screwdriver with its tip wrapped in protective tape, release the airbag connector lock and disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

*a

Airbag connector

*b

Airbag Connector Lock

*c

Protective tape

(d) Using needle-nose pliers, remove the clip pins.

NOTICE:

Take care not to damage the pins.

*A

for type A

*B

for type B

*1

Clip

*2

Curtain airbag clip spacer

*a

Pin

*b

Claw (A)

*c

Claw (B)

*d

Spacer location

(e) Using 2 screwdrivers, release the claws (A) from the clips to detach the clips from the vehicle body, as shown in the illustration.

HINT:

Detach the clips and the curtain airbag assembly from the vehicle body as one unit.

(f) Release the claws (B).

(g) While holding the curtain airbag assembly, remove the 3 bolts and release the hooks to remove the curtain airbag assembly.

(h) Remove the curtain airbag clip and the curtain airbag clip spacer from the curtain airbag assembly.