Installation
INSTALLATION
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. INSTALL CURTAIN AIRBAG ASSEMBLY
NOTICE:
When installing the curtain airbag assembly, ask for help holding it to prevent it from bending.
(a) Make sure the ignition switch is in the OFF position.
(b) Make sure the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Engage the hooks and claws (A) to temporarily install the curtain airbag assembly.
*A |
for type A |
*B |
for type B |
*1 |
Clip |
*2 |
Curtain airbag clip spacer |
*a |
Pin |
*b |
Claw (A) |
*c |
Claw (B) |
*d |
Spacer location |
(d) Install 3 new bolts.
Torque:
11 N·m {112 kgf·cm, 8 ft·lbf}
NOTICE:
Do not twist the curtain airbag assembly when installing it.
(e) Install the curtain airbag assembly using a new spacer and new clip.
HINT:
Engage the claws (B) to install each new clip.
(f) Using needle-nose pliers, push the pins into the clips.
NOTICE:
- Take care not to damage the pins.
- Make sure the clip pins are firmly pushed in.
(g) Connect the airbag connector. NOTICE: When connecting any airbag connector, take care not to damage the airbag wire harness. |
|
(h) Push in the airbag connector lock to install the airbag connector.
NOTICE:
Make sure the airbag connector lock is locked securely.
2. INSTALL ROOF HEADLINING ASSEMBLY
Click here![]()
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here![]()
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
4. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here![]()
5. CHECK SRS WARNING LIGHT
Click here![]()
