Axle and Differential
Removal
In this manual: Axle and Differential
~1min read
REMOVAL
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
![]()
2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY
Click here![]()
3. REMOVE REAR DISC
Click here
![]()
4. DISCONNECT SKID CONTROL SENSOR WIRE
(a) Using a screwdriver with its tip wrapped in protective tape, disconnect the skid control sensor connector from the rear axle hub and bearing assembly. NOTICE: Be careful not to damage the rear axle hub and bearing assembly or the connector cover. |
![]() |
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a) Remove the 4 bolts, the rear axle hub and bearing assembly, and the rear disc brake dust cover subassembly from the rear axle beam subassembly. |
![]() |
Was this page helpful?

