Axle and Differential

Inspection On Vehicle

~1min read

INSPECTION ON VEHICLE

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here

2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY

Click here

3. REMOVE REAR DISC

Click here

4. CHECK REAR AXLE HUB BEARING PRELOAD

(a) Using a dial indicator, check the play near the center of the rear axle hub.

Maximum looseness:

0.05 mm (0.00196 in)

NOTICE:

  • Make sure the dial indicator is perpendicular to the measuring surface.
  • Keep the dial indicator magnet away from the rear axle hub and bearing assembly.

HINT:

If the looseness is greater than the maximum, replace the rear axle hub and bearing assembly.

5. CHECK REAR AXLE HUB OUT-OF-ROUND

(a) Using a dial indicator, check the out-of-round on the surface of the rear axle hub, outside the rear axle hub bolts.

Maximum out-of-round:

0.05 mm (0.00196 in)

NOTICE:

  • Make sure the dial indicator is perpendicular to the measuring surface.
  • Make sure to position the dial indicator tip on the outside of the rear axle hub bolts.
  • Keep the dial indicator magnet away from the rear axle hub and bearing assembly.

HINT:

If the out-of-round is greater than the maximum, replace the rear axle hub and bearing assembly.

6. INSTALL REAR DISC

Click here

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Click here

8. INSTALL REAR WHEEL

Click here