Axle and Differential

Installation

~1min read
03060901201509066N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly and the rear disc brake dust cover subassembly onto the rear axle beam subassembly with the 4 bolts.

Torque:

90 N·m {918 kgf·cm, 66 ft·lbf}

2. INSTALL REAR DISC

Click here

3. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Click here

4. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY

Click here

5. REMOVE REAR DISC

Click here

6. CHECK REAR AXLE HUB BEARING PRELOAD

Click here

7. CHECK REAR AXLE HUB OUT-OF-ROUND

Click here

8. INSTALL REAR DISC

Click here

9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Click here

10. CONNECT SKID CONTROL SENSOR WIRE

(a) Connect the skid control sensor connector to the rear axle hub and bearing assembly.

11. INSTALL REAR WHEEL

Click here

12. CHECK WHEEL SPEED SENSOR SIGNAL

Click here