Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during transmission speed sensor removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Required Procedure | Effect/Inoperative function when procedure not performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
PROCEDURE
1. PRECAUTIONS
NOTICE:
After turning the ignition switch OFF, a waiting period may be required before disconnecting the negative (-) battery cable. Therefore, be sure to read the negative (-) battery cable disconnection notice carefully before performing the work.
Click here
![]()
2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL
Click here![]()
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
3. REMOVE BATTERY
Click here![]()
4. REMOVE NO. 2 VALVE COVER
Click here![]()
5. REMOVE RADIATOR COVER
Click here
![]()
6. REMOVE NO. 1 AIR CLEANER INLET
Click here
![]()
7. REMOVE AIR CLEANER COVER WITH AIR CLEANER HOSE
Click here
![]()
8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Click here
![]()
9. REMOVE ECM
Click here
![]()
10. REMOVE BATTERY CLAMP SUB-ASSEMBLY
Click here
![]()
11. REMOVE TRANSMISSION SPEED SENSOR (NIN)
(a) Disconnect the connector.
(b) Remove the bolt and transmission speed sensor (NIN) from the CVT transaxle assembly.
(c) Remove the O-ring from the transmission speed sensor (NIN).
12. REMOVE TRANSMISSION SPEED SENSOR (NOUT)
(a) Disconnect the connector.
(b) Remove the bolt and transmission speed sensor (NOUT) from the CVT transaxle assembly.
(c) Remove the O-ring from the transmission speed sensor (NOUT).
13. REMOVE TRANSMISSION SPEED SENSOR (NT)
(a) Disconnect the connector.
(b) Remove the bolt and transmission speed sensor (NT) from the CVT transaxle assembly.
(c) Remove the O-ring from the transmission speed sensor (NT).
.gif)