K114 Continuously Variable Transmission

Installation

~2min read
010203040505.44N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION SPEED SENSOR (NT)

(a) Apply Toyota genuine CVT FE fluid to a new O-ring.

(b) Install the O-ring to the transmission speed sensor (NT).

(c) Install the transmission speed sensor (NT) to the CVT transaxle assembly with the bolt.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

(d) Connect the connector.

2. INSTALL TRANSMISSION SPEED SENSOR (NOUT)

(a) Apply Toyota genuine CVT FE fluid to a new O-ring.

(b) Install the O-ring to the transmission speed sensor (NOUT).

(c) Install the transmission speed sensor (NOUT) to the CVT transaxle assembly with the bolt.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

(d) Connect the connector.

3. INSTALL TRANSMISSION SPEED SENSOR (NIN)

(a) Apply Toyota genuine CVT FE fluid to a new O-ring.

(b) Install the O-ring to the transmission speed sensor (NIN).

(c) Install the transmission speed sensor (NIN) to the CVT transaxle assembly with the bolt.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

(d) Connect the connector.

4. INSTALL BATTERY CLAMP SUB-ASSEMBLY

Click here

5. INSTALL ECM

Click here

6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Click here

7. INSTALL AIR CLEANER COVER WITH AIR CLEANER HOSE

Click here

8. INSTALL NO. 1 AIR CLEANER INLET

Click here

9. INSTALL RADIATOR COVER

Click here

10. INSTALL BATTERY

Click here

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

12. INSTALL NO. 2 VALVE COVER

Click here

13. INSPECT DATA LIST

Click here