Brake hold
The brake hold system keeps the brakes applied when the shift lever is not in P or R (Multidrive) or in R (manual transmission), with the system active and after you have depressed the brake pedal to stop the vehicle. The system releases the brakes when you depress the accelerator pedal while the shift lever is not in P or N (Multidrive) or in N (manual transmission), to allow the vehicle to start moving smoothly.
Activating the brake hold system
The brake hold standby indicator light (green) comes on. While the system is holding the brakes applied, the brake hold operating indicator light (amber) is on.

■ Brake hold operating conditions The brake hold system does not operate under the following conditions:
- The driver's door is not closed.
- The driver is not wearing the seat belt.
If any of the above conditions is detected while the brake hold system is active, the system deactivates and the brake hold standby indicator light turns off. In addition, if any of these conditions is detected while the system is holding the brakes, a buzzer sounds and a message is displayed on the multi-information display. The parking brake is then automatically applied.
■ Brake hold function
- If the brake pedal is released for about 3 minutes after the system has started holding the brakes, the parking brake is automatically applied. In this case, a buzzer sounds and a warning message appears on the multi-information display.
- To deactivate the system while it is holding the brakes, firmly depress the brake pedal and press the switch again.
- The brake hold function may not be able to hold the vehicle on a steep hill. In this case, the driver may need to apply the brakes. The driver is alerted to this situation by a warning buzzer and a message on the multi-information display. If a warning message appears on the multi-information display, read it and follow its instructions.
■ When the parking brake is automatically applied while the system is holding the brakes While depressing the brake pedal, release the parking brake by operating its switch, and make sure the parking brake indicator light turns off.
■ If the message "Brake hold malfunction. Apply brake to deactivate system. Visit dealer." appears on the multi-information display The system may be malfunctioning. Have the vehicle inspected as soon as possible by a Toyota dealer, an authorized Toyota repairer, or any reliable repairer.
■ Warning buzzers and messages The system uses warning buzzers and messages to indicate a system malfunction or to alert the driver to the need for attention.
If a warning message is displayed on the multi-information display, read it and follow its instructions.
■ If the brake hold system indicator light flashes
WARNING■ When the vehicle is on a steep hill Be careful when using the brake hold system on a steep hill. The brake hold function may not be able to hold the vehicle in such a situation.
■ When stopped on a slippery road The system cannot stop the vehicle once the tire grip limit has been exceeded. Do not use the system when stopped on a slippery road.
NOTE■ When parking the vehicle The brake hold system is not designed for use when parking the vehicle for a long time. If you turn the ignition switch off while the system is holding the brakes, the brakes may release and the vehicle may move. When you need to operate the ignition switch, depress the brake pedal, shift the shift lever to P (Multidrive) or N (manual transmission), and apply the parking brake.