Parking Assist / Monitor System

Precautions

~3min read

PRECAUTION

IGNITION SWITCH TERMS

(a) The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.

Term

Ignition Switch (Position)

Engine Switch (Condition)

Ignition Switch in OFF position

LOCK

OFF (Locked)

Ignition Switch in ACC position

ACC

ON (ACC)

Ignition Switch in ON position

ON

ON (IG)

Starting the engine

START

ON (Starting)

POINTS TO NOTE DURING MAINTENANCE

(a) Observe the following points during maintenance.

(b) When the rear view camera assembly lens is dirty, clean it carefully with water and wipe with a soft cloth to obtain a clear image. If it is very dirty, use a neutral detergent.

(c) When replacing the radio and display receiver assembly or the navigation ECU, always replace it with a new part. If a radio and display receiver assembly or navigation ECU that has been used on another vehicle is installed, the following may occur.

  • A communication malfunction DTC may be stored.
  • The radio and display receiver assembly or navigation ECU may not operate correctly.

NOTES ON THE REAR VIEW CAMERA ASSEMBLY

(a) Notes on the rear view camera assembly.

(1) The back monitor system may not operate correctly if it is struck violently by a hard object.

(2) Do not scrape the camera lens. Scraping may scratch the camera lens and affect the image.

(3) The camera protective cover is made of resin. Avoid covering the protective cover with organic solvent, wax, adhesive residue remover or other coatings. If such a substance adheres to the cover, clean it off immediately and rinse with water.

(4) Exposing the camera to sudden temperature changes may affect its correct operation.

(5) The image may not appear clearly if the camera is covered with snow, mud, etc. In this case, clean with water and wipe the lens. If necessary, use a detergent to remove dirt.

(6) When washing the vehicle with a high-pressure cleaner, do not spray water onto the rear view camera assembly or the area around it. High-pressure water may damage the camera.

(b) Images may appear even under normal conditions if:

(1) Electrical devices are used inside the cabin (interference may appear on the image).

(2) Accessories that emit radio waves are installed (interference may appear on the image).

(3) The outside rear view mirror switch assembly is operated (interference may appear on the image).

(4) The multi-display is cold (immediately after the ignition switch is turned to ON, the image may be blurred or darker than normal).

(5) The camera lens is covered with snow, mud, etc.

(6) A dazzling light beam (sunlight or headlights) strikes the camera.

(7) It is too dark around the camera (at night, etc.).

(8) The ambient temperature around the camera is too high or too low.

(9) The vehicle is tilted significantly.

(10) The rear view camera assembly lens is scratched.

(11) Water droplets are on the rear view camera assembly lens or humidity is high.

(12) When the camera is used under fluorescent, sodium or mercury lighting, etc., the lights and illuminated area may appear to flicker.