Exterior Panels / Trim
Installation
In this manual: Exterior Panels / Trim
~1min read
INSTALLATION
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. INSTALL THE FRONT DOOR BELT MOULDING ASSEMBLY
![]() |
Install in this direction |
(a) Engage the claws to install a new front door belt moulding assembly, as shown in the illustration.
(b) Remove the protective tape.
2. INSTALL THE FRONT DOOR GLASS SUB-ASSEMBLY
Click here
![]()
3. INSTALL THE FRONT DOOR SERVICE HOLE COVER
Click here
![]()
4. INSTALL THE OUTSIDE REAR VIEW MIRROR ASSEMBLY
Click here
![]()
5. CONNECT THE CABLE TO THE NEGATIVE BATTERY TERMINAL
Click here![]()
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
6. INITIALIZE THE POWER WINDOW CONTROL SYSTEM
Click here![]()
7. CHECK THE POWER WINDOW OPERATION
Click here
![]()
Was this page helpful?
.png)