Heater / Air Conditioning
Relay
In this manual: Heater / Air Conditioning
~1min read
Inspection On Vehicle
INSPECTION ON VEHICLE
PROCEDURE
1. INSPECT PTC HEATER RELAY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) shown in the table below.
*a |
Component without wire harness connected (PTC HTR No. 1) |
*b |
Component without wire harness connected (PTC HTR No. 2) |
*c |
Component without wire harness connected (PTC HTR No. 3) |
- |
- |
Standard resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
3 - 5 |
Battery voltage not applied between terminals 1 and 2 |
10 kΩ minimum |
3 - 5 |
Battery voltage applied between terminals 1 and 2 |
Below 1 Ω |
If the result is not as specified, replace the PTC heater relay.
Was this page helpful?