Brake System (Other)

Reassembly

~1min read
0102030405043N·mlb·ft
Tightening torque found on this page

REASSEMBLY

PROCEDURE

1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

(a) Install the brake master cylinder reservoir strainer to the brake master cylinder reservoir assembly.

2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

(a) Install the brake master cylinder reservoir filler cap assembly to the brake master cylinder reservoir assembly.

3. INSTALL BRAKE MASTER CYLINDER RESERVOIR GROMMET

(a) Apply an even coat of lithium soap based glycol grease around the entire circumference of the 2 new brake master cylinder reservoir grommets.

(b) Install the 2 brake master cylinder reservoir grommets to the brake master cylinder reservoir assembly.

4. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

(a) Place the brake master cylinder body in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the brake master cylinder body.

(b) Install the brake master cylinder reservoir assembly to the brake master cylinder body.

NOTICE:

Do not drop the brake master cylinder reservoir assembly.

(c) Using a TORX T20 socket wrench, install the brake master cylinder reservoir assembly to the brake master cylinder body with the TORX screw.

Torque:

4 N·m {41 kgf·cm, 35 in·lbf}

(d) Remove the brake master cylinder sub-assembly from the vise.