Brake System (Other)

Installation

~2min read
0102030405012.79N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL BRAKE BOOSTER GASKET

(a) Install a new gasket on the brake booster assembly.

2. INSTALL BRAKE BOOSTER ASSEMBLY

(a) Temporarily install the brake booster assembly on the vehicle body.

NOTICE:

Be careful not to damage the brake lines or the refrigerant lines.

(b) Install the clevis lock nut and the master cylinder brake push rod clevis on the brake booster assembly.

NOTICE:

Fully tighten the clevis lock nut after adjusting the brake pedal height.

(c) Install the 4 nuts and secure the brake booster assembly.

Torque:

12.7 N·m {130 kgf·cm, 9 ft·lbf}

NOTICE:

Tighten the 4 nuts in the order shown in the illustration.

(d) Remove the protective tape.

(e) Engage the 2 clips to install the fuel tube on the fuel tube clamp.

(f) Engage the 4 clips to install the brake tube on the 2 brake tube clamps.

(g) Connect the vacuum switch assembly connector.

3. CONNECT HOSE CONNECTING CHECK VALVE TO CONNECTOR PIPE

(a) Connect the hose connecting the check valve to the connector pipe on the brake booster assembly and slide the clip to secure it.

4. INSTALL INSTRUMENT PANEL INSULATOR

(a) Temporarily install the instrument panel insulator on the vehicle body using the 2 nuts (A).

(b) Install the nut (B).

Torque:

5 N·m {51 kgf·cm, 44 in·lbf}

(c) Tighten the 2 nuts (A).

Torque:

5 N·m {51 kgf·cm, 44 in·lbf}

5. INSTALL ENGINE UNDER COVER NO. 1

Click here

6. INSTALL PUSH ROD PIN

Click here

7. INSTALL BRAKE PEDAL RETURN SPRING

Click here

8. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Click here

9. INSPECT AND ADJUST BRAKE PEDAL

Click here