Interior Light

Installation

~1min read
0102030405064N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the right and left sides.
  • The procedure described below applies to the left side.

PROCEDURE

1. INSTALL REAR DOOR SILL LIGHT SWITCH ASSEMBLY

(a) Using a TORX socket wrench T30, install the rear door sill light switch assembly with the bolt.

Install in this direction

Torque:

6 N·m {61 kgf·cm, 53 in·lbf}

(b) Connect the connector.

2. INSTALL REAR SEAT SIDE GARNISH (with rear seat side airbag)

Click here

3. INSTALL REAR SEAT SIDE GARNISH (without rear seat side airbag)

Click here

4. INSTALL REAR PILLAR GARNISH (with rear seat side airbag)

Click here

5. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY

Click here

6. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

(a) Connect the rear door opening trim weatherstrip to the area shown in the illustration.

7. INSTALL REAR DOOR SCUFF PLATE (with rear seat side airbag)

Click here

8. INSTALL REAR DOOR SCUFF PLATE (without rear seat side airbag)

Click here

9. INSTALL REAR SEAT ASSEMBLY

Click here