Interior Light

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT REAR DOOR SILL LIGHT SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - Switch Body

Not depressed (ON)

Below 1 Ω

Depressed (OFF)

10 kΩ minimum

If the result is not as specified, replace the rear door sill light switch assembly.

*a

Component without wire harness connected

(rear door sill light switch assembly)

*b

Switch Body