Installation
INSTALLATION
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY NO. 1
(a) Engage the guide to install the rear door lock remote control cable assembly No. 1 onto the rear door lock assembly with motor. |
![]() |
(b) Engage the claws as shown in the illustration.
![]() |
Install in this direction |
2. INSTALL REAR DOOR INSIDE LOCK CABLE ASSEMBLY
(a) without Double Lock System:
(1) Engage the guide to install the rear door inside lock cable assembly onto the rear door lock assembly with motor. |
![]() |
(2) Engage the claws as shown in the illustration.
![]() |
Install in this direction |
(b) with Double Lock System:
(1) Engage the guide to install the rear door inside lock cable assembly onto the rear door lock assembly with motor. |
![]() |
(2) Engage the claws as shown in the illustration.
![]() |
Install in this direction |
3. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
(a) without Double Lock System:
(1) Engage the guide to install the rear door lock remote control cable assembly onto the rear door lock assembly with motor. |
![]() |
(2) Engage the claw as shown in the illustration.
![]() |
Install in this direction |
(b) with Double Lock System:
(1) Engage the guide to install the rear door lock remote control cable assembly onto the rear door lock assembly with motor.
(2) Engage the claw as shown in the illustration.
![]() |
Install in this direction |
4. INSTALL REAR DOOR LOCK ASSEMBLY WITH MOTOR
NOTICE:
- If reusing a removed rear door lock assembly with motor, replace the door lock wire harness gasket with a new one.
- Do not allow grease or dust to adhere to the door lock wire harness gasket installation surface.
- Reusing a door lock wire harness gasket or using a damaged door lock wire harness gasket may cause water leakage. This may cause a malfunction of the rear door lock assembly with motor.
(a) Apply MP grease to the sliding parts of the rear door lock assembly with motor.
(b) If reusing the rear door lock assembly with motor:
(1) Install a new door lock wire harness gasket onto the rear door lock assembly with motor.
(c) Using a "TORX" T30 socket wrench, install the rear door lock assembly with motor with 3 screws.
![]() |
Install in this direction |
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(d) Connect the connector.
5. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY
Click here
![]()
6. INSTALL REAR DOOR OUTSIDE HANDLE COVER
Click here
![]()
7. INSTALL THE REAR DOOR SERVICE HOLE COVER
Click here
![]()
8. INSTALL REAR DOOR TRIM BRACKET
Click here
![]()
9. INSTALL REAR DOOR TRIM PANEL SUB-ASSEMBLY
Click here
![]()
10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
Click here
![]()
11. INSTALL REAR DOOR INSIDE HANDLE GARNISH CLIP
Click here
![]()
12. INSTALL REAR DOOR REAR SASH BRACKET
Click here
![]()
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here![]()
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
14. INITIALIZE POWER WINDOW CONTROL SYSTEM
Click here![]()
15. CHECK POWER WINDOW OPERATION
Click here![]()

.png)


