K114 Continuously Variable Transmission

Installation

~2min read
010203040506.95N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL PARK/NEUTRAL POSITION SWITCH

(a) Temporarily install the park/neutral position switch onto the CVT transaxle assembly using the 2 bolts.

(b) Install the lock plate and lock nut onto the park/neutral position switch.

Torque:

6.9 N·m {70 kgf·cm, 61 in·lbf}

(c) Temporarily install the control shaft lever onto the park/neutral position switch.

(d) Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 detents.

(e) Remove the control shaft lever from the park/neutral position switch.

(f) Align the projection with the neutral basic line.

*a

Neutral basic line

*b

Protrusion

(g) Hold the park/neutral position switch in this position and tighten the 2 bolts.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

(h) Using a screwdriver, stake the lock nut with the lock plate.

(i) Install the control shaft lever onto the park/neutral position switch using the washer and nut.

Torque:

12.7 N·m {130 kgf·cm, 9 ft·lbf}

(j) Connect the park/neutral position switch connector.

2. CONNECT CONTROL CABLE ASSEMBLY

(a) Connect the shift control cable assembly to the No. 1 shift control cable bracket using a new clip.

(b) Turn the control shaft lever clockwise until it stops, then turn it 2 detents counterclockwise.

*a

P Position

*b

N Position

(c) Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque:

12 N·m {122 kgf·cm, 9 ft·lbf}

3. CHECK SHIFT LEVER POSITION

Click here

4. ADJUST SHIFT LEVER POSITION

Click here

5. INSPECT PARK/NEUTRAL POSITION SWITCH OPERATION

Click here

6. ADJUST PARK/NEUTRAL POSITION SWITCH

Click here

7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Click here

8. INSTALL AIR CLEANER COVER WITH AIR CLEANER HOSE

Click here

9. INSTALL AIR CLEANER INLET NO. 1

Click here

10. INSTALL RADIATOR SHROUD

Click here

11. INSTALL NO. 2 VALVE COVER

Click here

12. INSTALL LH REAR ENGINE UNDER COVER

Click here

13. INSTALL NO. 1 ENGINE UNDER COVER

Click here