Inspection
INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH
*a |
Component without wire harness connected (park/neutral position switch) |
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
4 (B) - 9 (L) |
Shift lever in P or N |
Below 1 Ω |
Shift lever in position other than P or N |
10 kΩ minimum |
|
1 (RB) - 3 (PL) |
Shift lever in P position |
Below 1 Ω |
Shift lever in position other than P |
10 kΩ minimum |
|
1 (RB) - 2 (RL) |
Shift lever in R position |
Below 1 Ω |
Shift lever in position other than R |
10 kΩ minimum |
|
1 (RB) - 8 (NL) |
Shift lever in N |
Below 1 Ω |
Shift lever in position other than N |
10 kΩ minimum |
|
1 (RB) - 7 (DL) |
Shift lever in D or M |
Below 1 Ω |
Shift lever in position other than D or M |
10 kΩ minimum |
If the result is not as specified, replace the park/neutral position switch.