Wiper / Washer
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT WIPER SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance: Front Wiper Switch
Tester Connection | Condition | Specified Condition |
F26-2 (+B) - F26-3 (+1) |
MIST |
Below 1 Ω |
F26-3 (+1) - F26-1 (+S) |
OFF |
F26-3 (+1) - F26-1 (+S) |
AUTO |
F26-8 (AUTO) - F26-9 (E) |
F26-2 (+B) - F26-3 (+1) |
LO |
F26-2 (+B) - F26-4 (+2) |
HI |
Front Washer Switch
Tester Connection | Condition | Specified Condition |
F36-4 (EW) - F36-7 (WF) |
ON |
Below 1 Ω |
F26-5 (WR) - F26-10 (+B2) |
F36-4 (EW) - F36-7 (WF) |
OFF |
10 kΩ minimum |
F26-5 (WR) - F26-10 (+B2) |
Rear Wiper Switch
Tester Connection | Condition | Specified Condition |
F36-2 (C1R) - F36-4 (EW) |
OFF |
10 kΩ minimum |
F36-3 (+1R) - F36-4 (EW) |
F36-2 (C1R) - F36-4 (EW) |
INT |
Below 1 Ω |
F36-3 (+1R) - F36-4 (EW) |
ON |
Rear Washer Switch
Tester Connection | Condition | Specified Condition |
F36-4 (EW) - F26-5 (WR) |
ON |
Below 1 Ω |
F36-7 (WF) - F26-10 (+B2) |
F36-4 (EW) - F26-5 (WR) |
OFF |
10 kΩ minimum |
F36-7 (WF) - F26-10 (+B2) |
Adjustment Ring*
Tester Connection | Condition | Specified Condition |
F26-6 (VR2) - F26-7 (VR1) |
P1 |
209 à 231 Ω |
P2 |
114 à 126 Ω |
P3 |
58,9 à 65,1 Ω |
P4 |
Below 1 Ω |
HINT:
*: The rain sensor sensitivity can be adjusted using the wiper switch adjustment ring.
If the result is not as specified, replace the front wiper switch assembly. |
 |
*1 |
Front Wiper Switch Assembly
(Ring Position Adjustment) |
*a |
Component without wire harness connected
(front wiper switch assembly) |
|
|
Was this page helpful?