Wiper / Washer
Inspection On Vehicle
In this manual: Wiper / Washer
~1min read
INSPECTION ON VEHICLE
PROCEDURE
1. INSPECT FRONT WIPER SWITCH ASSEMBLY
(a) Check the operation of the front washer.
(1) Connect the positive (+) voltmeter lead to terminal F36-7 (WF) and the negative (-) lead to terminal F36-4 (EW). |
|
(2) Turn the ignition switch ON.
(3) Set the washer switch to ON, then OFF, and check the voltage between terminals F36-7 (WF) and F36-4 (EW).
OK:
The voltage changes as shown in the illustration.
If the result is not as specified, replace the front wiper switch assembly.
Was this page helpful?
