Wiper / Washer

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT REAR WIPER MOTOR ASSEMBLY

*a

Component without wire harness connected

(Rear Wiper Motor Assembly)

(a) Check that the rear wiper motor assembly operates.

NOTICE:

Check whether the body ground is connected.

(1) Apply battery voltage to the rear wiper motor connector and check the speed of the rear wiper motor assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 4 (+B)

Battery negative (-) → Terminal 3 (LS)

Battery negative (-) → Terminal 5 (E)

Motor operates

If the result is not as specified, replace the rear wiper motor assembly.

(b) Check the intermittent wiper operation.

NOTICE:

Check whether the body ground is connected.

(1) Apply battery voltage to the rear wiper motor connector and check the speed of the rear wiper motor assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 4 (+B)

Battery negative (-) → Terminal 2 (C1)

Battery negative (-) → Terminal 5 (E)

Motor operates

If the result is not as specified, replace the rear wiper motor assembly.

*a

Component without wire harness connected

(Rear Wiper Motor Assembly)