Wiper / Washer

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT FRONT WASHER PUMP AND MOTOR ASSEMBLY (for front side)

HINT:

Perform this inspection with the front washer pump and motor assembly installed on the washer reservoir assembly.

(a) Fill the front washer reservoir assembly with washer fluid.

(b) Check that washer fluid flows from the front washer reservoir assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 2 (+)

Battery negative (-) → Terminal 1 (-)

Washer fluid flows from the front washer reservoir assembly

If the result is not as specified, replace the front washer pump and motor assembly.

*a

Component without wire harness connected (front wiper and washer pump and motor assembly)

2. INSPECT FRONT WASHER PUMP AND MOTOR ASSEMBLY (for rear side)

HINT:

Perform this inspection with the front washer pump and motor assembly installed on the washer reservoir assembly.

(a) Fill the front washer reservoir assembly with washer fluid.

(b) Check that washer fluid flows from the front washer reservoir assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) terminal → Terminal 1 (+)

Battery negative (-) → Terminal 2 (-)

Washer fluid flows from the front washer reservoir assembly

If the result is not as specified, replace the front washer pump and motor assembly.

*a

Component without wire harness connected (front wiper and washer pump and motor assembly)