Doors / Back Door
Inspection
INSPECTION
PROCEDURE
1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (with Smart Key System)
(a) Check the operation of the back door opener switch.
(1) Measure the resistance according to the value(s) shown in the table below.
Standard resistance:
Tester Connection | Ignition switch position | Specified Condition |
3 (UL) - 2 (E) |
Back door opener switch pressed (ON) |
Below 1 Ω |
3 (UL) - 2 (E) |
Back door opener switch not pressed (OFF) |
10 kΩ minimum |
If the result is not as specified, replace the back door opener switch assembly. |
 |
*a |
Not pressed (OFF) |
*b |
Pressed (ON) |
*c |
Component without wire harness connected
(back door opener switch assembly) |
|
|
(b) Check the operation of the back door lock switch.
(1) Measure the resistance according to the value(s) shown in the table below.
Standard resistance:
Tester Connection | Ignition switch position | Specified Condition |
1 (L) - 2 (E) |
Back door lock switch pressed (ON) |
Below 1 Ω |
1 (L) - 2 (E) |
Back door lock switch not pressed (OFF) |
10 kΩ minimum |
If the result is not as specified, replace the back door opener switch assembly. |
 |
*a |
Not pressed (OFF) |
*b |
Pressed (ON) |
*c |
Component without wire harness connected
(back door opener switch assembly) |
|
|
2. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (without Smart Key System)
(a) Check the operation of the back door opener switch.
(1) Measure the resistance according to the value(s) shown in the table below.
Standard resistance:
Tester Connection | Ignition switch position | Specified Condition |
3 (UL) - 2 (E) |
Back door opener switch pressed (ON) |
Below 1 Ω |
3 (UL) - 2 (E) |
Back door opener switch not pressed (OFF) |
10 kΩ minimum |
If the result is not as specified, replace the back door opener switch assembly. |
 |
*a |
Not pressed (OFF) |
*b |
Pressed (ON) |
*c |
Component without wire harness connected
(back door opener switch assembly) |
|
|
Was this page helpful?