Brake Control / Dynamic Control Systems

Inspection On Vehicle

~3min read

INSPECTION ON VEHICLE

PRECAUTION / NOTICE / HINT

PROCEDURE

1. CONNECT TECHSTREAM

(a) Connect the Techstream to the DLC3 with the ignition switch OFF.

(b) Start the engine and let it idle.

(c) Turn on the Techstream.

(d) Select the following menus: Chassis / ABS/VSC/TRC/EPB / Active Test.

HINT:

Refer to the Techstream operator's manual for more information.

2. CHECK BRAKE ACTUATOR MOTOR OPERATION

(a) Select the following menu items: Chassis / ABS/VSC/TRC/EPB / Active Test / Motor Relay.

Chassis > ABS/VSC/TRAC/EPB > Active Test

Motor Relay

(b) Turn on the motor relay and check that the actuator motor makes an operating noise.

NOTICE:

Do not keep the motor relay on for more than 5 seconds at a time. When repeating the test, wait more than 20 seconds between each operation.

(c) Turn off the motor relay.

(d) Fully depress the brake pedal and hold it in this position for approximately 15 seconds. Make sure the brake pedal stays depressed for the full 15 seconds.

(e) Turn on the motor relay and check that the brake pedal does not vibrate.

NOTICE:

Do not keep the motor relay on for more than 5 seconds at a time. When repeating the test, wait more than 20 seconds between each operation.

(f) Turn off the motor relay and release the brake pedal.

3. CHECK FRONT RH WHEEL OPERATION

(a) Select the following menu items: Chassis / ABS/VSC/TRC/EPB / Active Test / ABS Solenoid.

Chassis > ABS/VSC/TRAC/EPB > Active Test

ABS Solenoid

(b) Depress the brake pedal and hold it in this position.

NOTICE:

Never activate a solenoid valve in any way other than as described below.

(c) Simultaneously turn on the SFRH and SFRR solenoid valves and check that the brake pedal cannot be depressed any further.

NOTICE:

Each solenoid valve operates for 2 seconds and then turns off automatically. When repeating the test on a solenoid valve, wait more than 20 seconds between each operation.

(d) Simultaneously turn off the SFRH and SFRR solenoid valves and check that the brake pedal goes down.

(e) With the brake pedal still depressed, select the following menu items: Chassis / ABS/VSC/TRC/EPB / Active Test / Motor Relay.

Chassis > ABS/VSC/TRAC/EPB > Active Test

Motor Relay

(f) Turn on the motor relay and check that the brake pedal rises.

NOTICE:

Do not keep the motor relay on for more than 5 seconds at a time. When repeating the test, wait more than 20 seconds between each operation.

(g) Turn off the motor relay and release the brake pedal.

4. CHECK OPERATION OF THE OTHER WHEELS

(a) Check the solenoid valve coils of the other wheels by performing the same procedure.

HINT:

  • Front LH wheel: SFLH, SFLR
  • Rear RH wheel: SRRH, SRRR
  • Rear LH wheel: SRLH, SRLR