Axle and Differential

Inspection On Vehicle

~1min read

INSPECTION ON VEHICLE

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE FRONT WHEEL

Click here

2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY

Click here

3. REMOVE FRONT DISC

Click here

4. CHECK FRONT AXLE HUB BEARING PRELOAD

(a) Using a dial indicator, check that there is no play near the center of the front axle hub.

Maximum looseness:

0.05 mm (0.00196 in)

NOTICE:

  • Make sure the dial indicator is perpendicular to the measuring surface.
  • Keep the magnet of the dial indicator away from the front axle hub subassembly and the front speed sensor.
  • If the play exceeds the maximum value, replace the front axle hub subassembly.

5. INSPECT FRONT AXLE HUB OUT-OF-ROUND

(a) Using a dial indicator, check the out-of-round on the surface of the front axle hub subassembly, outside the front axle hub bolts.

Maximum out-of-round:

0.05 mm (0.00196 in)

NOTICE:

  • Make sure the dial indicator is perpendicular to the measuring surface.
  • Be sure to point the tip of the dial indicator toward the outside of the front axle hub bolts.
  • Keep the magnet of the dial indicator away from the front axle hub subassembly and the front speed sensor.
  • If the out-of-round exceeds the maximum value, replace the front axle hub subassembly.

6. INSTALL FRONT DISC

Click here

7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Click here

8. INSTALL FRONT WHEEL

Click here