Toyota Camry Quiz
Exterior/interior trim

Front door belt moulding assy LH

In this manual: Exterior/interior trim
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
8steps
~48min
2/5difficulty
Done 0 of 8
REPLACEMENT

HINT:

  • The installation procedures are the removal procedures in reverse order.
  • Use the same procedures for the RH side and LH side.
  1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSY
  2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
  4. REMOVE FRONT DOOR TRIM BOARD SUB−ASSY LH
  5. REMOVE OUTER REAR VIEW MIRROR ASSY LH
  6. REMOVE FRONT DOOR BELT MOULDING ASSY LH
  7. Put protective tape under the moulding.
  8. Using a moulding remover, pry out the moulding as shown in the illustration.

HINT: Tape the remover tip before use.

Remove front door belt moulding assy LH Remove front door belt moulding assy LH

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.