Brake

Speed front LH

8steps
~48min
2/5difficulty
0102030405086N·mlb·ft
Tightening torque found on this page
Done 0 of 8
REPLACEMENT

HINT: Replace the RH side by the same procedures with LH side.

  1. REMOVE FRONT WHEEL
  2. REMOVE FRONT FENDER LINER LH
  3. REMOVE SPEED FRONT LH

a Disconnect the speed connector and clamp.

b. Remove the 2 clamp bolts holding the  harness

b. Remove the 2 clamp bolts holding the harness and clamp from the body and shock absorber.

c. Remove the bolt and speed  FR LH.

c. Remove the bolt and speed FR LH.

NOTICE: Do not stick and foreign matter on the tip.
4. INSTALL SPEED  FRONT LH
4. INSTALL SPEED FRONT LH

a. Install the speed FR LH with the bolt.

Torque: 8 N·m NOTICE: Make sure the tip is clean.
  1. Install the harness clamps with the 2 bolts ”A” and ”B” to the body and shock absorber.

    Torque:
    Bolt A: 5 N·m Bolt B: 18,8 N·m
  2. Connect the clamp to the knuckle.

    d. Connect the speed  connector and clamp.

d. Connect the speed connector and clamp.

  1. INSTALL FRONT FENDER LINER LH
  2. INSTALL FRONT WHEEL Torque: 103 N·m
  3. CHECK ABS SPEED SIGNAL

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.