Brake

ABS Warning Light Remains ON

~1min read

DESCRIPTION

This procedure is for troubleshooting when the ABS warning light remains on but no DTCs are output.

The skid control ECU (brake actuator assembly) controls the ABS warning light in the combination meter assembly via CAN communication.

NOTICE:

Before performing this procedure, depress the brake pedal and confirm that the stop lights illuminate.

PROCEDURE

  1. CHECK VEHICLE CONTROL HISTORY (RoB) (ELECTRONICALLY CONTROLLED BRAKE SYSTEM AND ELECTRIC PARKING BRAKE SYSTEM)

(a) Using the GTS, check for Vehicle Control History (RoB).

Chassis > Brake/EPB > Utility

Vehicle Control History (RoB)

HINT:

If vehicle control history (RoB) is stored when the electronically controlled brake system and electric parking brake system are suspended, the ABS warning light illuminates.

Result

Proceed to

There is no vehicle control history (RoB) for when the electronically controlled brake system and electric parking brake system were suspended.

A

There is vehicle control history (RoB) for when the electronically controlled brake system and/or electric parking brake system were suspended.

B

B

PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY (RoB)

NOTICE:

After performing troubleshooting and repair regarding vehicle control history (RoB), clear the vehicle control history (RoB).

A
  1. INSPECT COMBINATION METER ASSEMBLY

(a) Perform the Active Test of the combination meter assembly using the GTS.

Click here

Body Electrical > Combination Meter > Active Test

ABS Warning

(b) Check the combination meter assembly.

OK:

The ABS warning light turns on or off in accordance with GTS operation.

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

INSPECT METER / GAUGE SYSTEM