Vehicle Interior

Blower Motor does not Operate

~2min read

DESCRIPTION

If air does not flow from the front registers after the blower switch on the air conditioning control assembly is operated, the following factors may be the cause.

Symptom

Factor

Blower motor does not operate at all

  • (Air does not blow from registers)
  • Air conditioning amplifier assembly malfunction
  • Blower motor with fan sub-assembly malfunction
  • Warm-up control
  • Engine coolant temperature sensor malfunction
  • Harness or connector

PROCEDURE

  1. CHECK AIR CONDITIONING SYSTEM (MANUAL MODE)

(a) Turn off the AUTO switch, operate the blower switch and check that the blower motor with fan sub-assembly can be operated manually.

OK:

The blower motor with fan sub-assembly operates normally.

NG

GO TO OTHER DIAGNOSIS PROCEDURE (Blower Motor Circuit)

OK
  1. READ VALUE USING GTS

(a) Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Coolant Temperature

Engine coolant temperature

Min.: -40°C (-40°F), Max.: 140 °C

75 to 100 °C: After warming up

This is the engine coolant temperature.

HINT:

  • After warming up the engine, the engine coolant temperature will be 75 to 100 °C.
  • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.
  • If the value is -40°C (-40°F), or higher than 135 °C, the sensor circuit is open or shorted.
  • Check if the engine overheats if the value indicated is higher than 135 °C.
Powertrain > Engine > Data List

Coolant Temperature

OK:

After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.

OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

GO TO COOLING SYSTEM