Recirculated/Fresh Air Modes Switch without User Input
DESCRIPTION
If recirculation/fresh mode changes unintentionally and without permission, the following causes are possible.
Symptom | Factor |
|---|---|
|
|
PROCEDURE
CHECK CUSTOMIZE SETTING
(a) Using the GTS, check that the customize setting Air Inlet Mode is not set to "Automatic".
Air ConditionerTester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
Efficient Ventilation Mode |
Function to change the mode automatically to recirculation air mode when turning the A/C on to cool the cabin quickly |
ON |
$00:OFF,$01:ON |
Air conditioning amplifier assembly |
OK:
Air Inlet Mode is not set to "Automatic".
| NG | CUSTOMIZE SETTING Set Air Inlet Mode to "Manual" |
|
READ VALUE USING GTS
(a) Read the Data List according to the display on the GTS.
Body Electrical > Air Conditioner > Data ListTester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
Ambient Temperature Sensor |
Thermistor assembly |
Min.: -327.68 °C Max.: 328 °C |
Actual ambient temperature displayed |
Thermistor assembly circuit malfunction |
Ambient Temperature Sensor
OK:
The value of the display does not change frequently.
| NG | GO TO AMBIENT TEMPERATURE DISPLAY SYSTEM |
|
READ VALUE USING GTS
(a) Read the Data List according to the display on the GTS.
Powertrain > Engine > Data ListTester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
Coolant Temperature |
Engine coolant temperature |
Min.: -40°C (-40°F), Max.: 140 °C |
75 to 100 °C: After warming up |
This is the engine coolant temperature. HINT:
|
Coolant Temperature
OK:
The value of the display does not change frequently.
| NG | GO TO COOLING SYSTEM |
|
CHECK REFRIGERANT PRESSURE
(a) Read the Data List according to the display on the GTS.
Body Electrical > Air Conditioner > Data ListTester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
Regulator Pressure Sensor |
Air conditioner pressure sensor |
Min.: -32768 kPa(gauge) Max.: 32767 kPa(gauge) |
Actual refrigerant pressure displayed |
Refrigerant line (gas leak etc.)
|
Regulator Pressure Sensor
(b) Install a manifold gauge set.
(c) Read the manifold gauge pressure when the following conditions are met.
(1) Prepare the vehicle according to the table below.
Measurement Condition:Item | Condition |
|---|---|
Vehicle doors |
Fully open |
Temperature setting |
MAX COLD |
Blower speed |
HI |
A/C switch |
On |
Recirculation/fresh switch |
RECIRCULATION |
Interior temperature |
25 to 35 °C |
Standard Pressure:
Low pressure side
150 to 250 kPa (1.5 to 2.5 kgf/cm2, 22 to 36 psi)
High pressure side
1370 to 1570 kPa (14 to 16 kgf/cm2, 199 to 228 psi)
(d) Compare the values displayed in the Data List and on the manifold gauge.
OK:
The values displayed in the Data List and on the manifold gauge match.
| OK | GO TO ON-VEHICLE INSPECTION (CHECK REFRIGERANT PRESSURE USING GAUGE) |
| NG | REPLACE AIR CONDITIONER PRESSURE SENSOR |