Vehicle Interior

Recirculated/Fresh Air Modes do not Switch

~2min read

DESCRIPTION

If the air inlet mode cannot be changed between recirculation/fresh or exhaust gas odors can be smelled even though recirculation mode is selected, the following factors may be the cause.

Symptom

Factor

  • Air inlet mode cannot be changed between recirculation/fresh
  • Exhaust gas odors can be smelled when air inlet mode set to recirculation mode
  • No. 1 blower damper servo sub-assembly malfunction
  • Damper link disconnection
  • Air inlet damper mechanically locked
  • Engine coolant temperature (high)
  • Air conditioner unit assembly malfunction

PROCEDURE

  1. CHECK NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY

(a) Check that the No. 1 blower damper servo sub-assembly is installed correctly.

OK:

The No. 1 blower damper servo sub-assembly is installed correctly.

NG

INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY

OK
  1. CHECK FOR DTC

(a) Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes

Result

Proceed to

B143A87 and B143B7F is not output

A

B143A87 is output

B

B143B7F is output

C

B

GO TO DTC B143A87

C

GO TO DTC B143B7F

A
  1. READ VALUE USING GTS

(a) Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Coolant Temperature

Engine coolant temperature

Min.: -40°C (-40°F), Max.: 140 °C

75 to 100 °C: After warming up

This is the engine coolant temperature.

HINT:

  • After warming up the engine, the engine coolant temperature will be 75 to 100 °C.
  • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.
  • If the value is -40°C (-40°F), or higher than 135 °C, the sensor circuit is open or shorted.
  • Check if the engine overheats if the value indicated is higher than 135 °C.
Powertrain > Engine > Data List

Coolant Temperature

OK:

After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.

OK

REPLACE AIR CONDITIONER UNIT ASSEMBLY

NG

GO TO COOLING SYSTEM