Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
PRECAUTION |
- |
- |
- |
|
2 |
REAR WHEEL |
- |
- |
- |
- |
3 |
PERFORM REAR BRAKE PAD REPLACEMENT MODE |
- |
- |
- |
|
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
4 |
NO. 2 PARKING BRAKE WIRE ASSEMBLY |
890C0A |
- |
- |
|
5 |
REAR DISC BRAKE CYLINDER ASSEMBLY |
- |
- |
- |
|
6 |
REAR DISC BRAKE PAD KIT |
04466 |
- |
- |
- |
7 |
REAR DISC BRAKE ANTI-SQUEAL SHIM KIT |
- |
- |
- |
|
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear disc brake pad removal/installation are shown below.
NOTICE:
- Immediately after installing the rear disc brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
- After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
- After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
Make sure to read the precautions of the electric parking brake system before removing the rear brake assembly.
- for HEV Model:
Click here
.gif)
- for Gasoline Model:
Click here
.gif)
2. REMOVE REAR WHEEL
Click here ![]()
3. PERFORM REAR BRAKE PAD REPLACEMENT MODE
- for HEV Model:
Click here
.gif)
- for Gasoline Model:
Click here
.gif)
4. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
![]() |
Click here |
5. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY
![]() |
CAUTION:
|
(1) Hold the rear disc brake cylinder slide pin (lower side) and remove the bolt.
(2) Pull the rear disc brake cylinder assembly upward.
6. REMOVE REAR DISC BRAKE PAD KIT
7. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
*1 |
Rear Disc Brake Anti-squeal Shim |
*2 |
Rear No. 2 Disc Brake Anti-squealShim |
(1) Remove the rear disc brake anti-squeal shim from the rear disc brake pad.
(2) Remove the rear disc brake anti-squeal shim and rear No. 2 disc brake anti-squeal shim from each rear disc brake pad.
(1) Using a screwdriver, remove the rear disc brake pad wear indicator plate from each rear disc brake pad.
.png)
.png)
.png)
