Toyota Corolla Quiz
Automatic transmission / trans

Adjustment

In this manual: Automatic transmission / trans
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
7steps
~42min
2/5difficulty
Done 0 of 7
1. Inspect park/neutral position switch assy
  1. apply the parking brake and turn the ignition switch on.
  2. depress the brake pedal and check that the engine starts only when the shift lever is set in n or p position and it does not start in the other position.
  3. check that the back–up light comes on and the reverse warning buzzer sounds only when the shift lever is set in r position and these do not function in the other positions.

    If a failure is found, check the park/ neutral position switch for continuity.

2. Adjust park/neutral position switch assy
Toyota Corolla. Adjust park/neutral position switch assy
  1. Loosen the 2 bolts of park/ neutral position switch and set the shift lever to the n position.
  2. align the groove and neutral basic line.
  3. hold the switch in position and tighten the 2 bolts.

    Torque: 5.5 Nvm (56 Kgf·cm, 49 in.Vlbf)

  4. after adjustment, perform the inspection described in step 1.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.