Toyota Corolla Quiz
Automatic transmission / trans

Replacement

In this manual: Automatic transmission / trans
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
6steps
~36min
2/5difficulty
Done 0 of 6
Hint

: components:

 1. Remove floor shift shift lever knob sub–assy 2. Remove console panel upper 3. Remove parking brake hole cover sub–assy 4. Remove console box sub–assy rear 5. Separate floor shift cable transmission control shift
Toyota Corolla. Separate floor shift cable transmission control shift
  1. Separate the end of the shift cable from the shift lever assy.
    Toyota Corolla. Separate floor shift cable transmission control shift
  2. Using a screwdriver, release the cable outer spring.
  3. turn the lock, separate the shift cable from the shift lever retainer.
6. Separate floor shift cable transmission control select
Toyota Corolla. Separate floor shift cable transmission control select
  1. Separate the end of the select cable from the shift lever assy.
    Toyota Corolla. Separate floor shift cable transmission control select
  2. Using a screwdriver, release the cable outer spring.
  3. turn the lock, separate the select cable from the shift lever retainer.
7. Remove floor shift shift lever assy
Toyota Corolla. Remove floor shift shift lever assy
  1. Remove the 4 bolts and shift lever assy.
8. Install floor shift shift lever assy
Toyota Corolla. Install floor shift shift lever assy
  1. Install the shift lever assy with the 4 bolts.

    Torque: 12 nvm (120 Kgf·cm, 9 ft·lbf)

9. Connect floor shift cable transmission control shift
Toyota Corolla. Connect floor shift cable transmission control shift
  1. Connect the shift cable to the retainer of shift lever assy, turn the lock.
Notice

: the projecting part of the lock should face upward when the shift cable is installed.
  • install the cable outer spring to the lock.
    • Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.
    Toyota Corolla. Connect floor shift cable transmission control shift
    1. Connect the end of the shift cable to the shift lever assy.
    10. Connect floor shift cable transmission control select
    Toyota Corolla. Connect floor shift cable transmission control select
    1. connect the select cable to the retainer of shift lever assy, turn the lock.
    Notice

    : the projecting part of the lock should face upward when the select cable is installed.
  • install the cable outer spring to the lock.
    • Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.
    Toyota Corolla. Connect floor shift cable transmission control select
    1. Connect the end of the select cable to the shift lever assy.

    Test yourself

    A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.