Replacement1. Remove engine under cover rh2. Remove front wheel rh3. Remove fan and generator v belt
Turn the v–ribbed belt tensioner slowly clockwise and loosen it. Then, remove the fan and generator belt v and put back the v–ribbed belt tensioner little by little and fix it quietly.
4. Remove engine mounting insulator sub–assy rh
Remove the the ps oil pump reservoir and put it aside.
place a wooden block between the jack and engine, and set the jack. Then, remove the 4 bolts, the 2 nuts and engine mounting insulator rh.
5. Remove crankshaft pulley
Using sst, remove the crankshaft pulley bolt.
Sst 09960–10010 (09962–01000, 09963–01000)
remove the crankshaft pulley from the crankshaft.
6. Remove timing gear cover oil seal
Using a knife, cut off the oil seal lip.
using a screwdriver with taping its tip, pry out the oil seal.
Notice
: after the removal, check if the crankshaft is not damaged.
If there is, mend it with a sandpaper (#400).
7. Install timing gear cover oil seal
Apply mp grease to a new oil seal lip.
Notice
: keep the lip off foreign materials.
using sst, tap in the oil seal until its surface is flush with the timing chain cover edge.
Sst 09223–22010
Notice
: wipe off extra grease on the crankshaft.
8. Install crankshaft pulley
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
