Compressor solenoid circuit (2006/01- )

In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier. Based on this signal, the compressor changes the degree of refrigerant compression.

*: Compressor and pulley for 2az-fe, compressor and magnetic clutch for 2gr-fe

1. 1
   Read value of intelligent tester (reg ctrl currnt)
2. 2
   Connect the intelligent tester (with can vim) to the dlc3.
3. 3
   Turn the ignition switch on and turn the intelligent tester main switch on.
4. 4
   Select the items below in the data list, and read the value displayed on the intelligent tester.

   

2. Inspect a/c compressor

1. 1
   Disconnect the a/c compressor connector.
2. 2
   Measure the resistance of the connector.

1. Check wire harness (a/c compressor - air conditioning amplifier)

1. 1
   Disconnect the b23 a/c compressor connector.
2. 2
   Disconnect the e36 amplifier connector.
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance

4. Check wire harness (a/c compressor - body ground)

1. 1
   Disconnect the b23 a/c compressor connector.
2. 2
   Measure the resistance of the wire harness side connector.

Standard resistance