Installation (2005/11-2006/01)

1. Install abs and traction actuator assembly with bracket

Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.

1. Install the actuator with bracket with the 3 nuts.

The nuts should be tightened in order from 1 to 3 as shown in the illustration.

Be careful not to damage the brake tubes.

2. Connect the brake tube clamp to the bracket.

1. 1
   Connect the connector and push the lock lever downward.
2. 2
   Connect brake lines

   

1. Using sst, connect the 6 brake lines to the correct locations on the actuator, as shown in the illustration.

Use a torque wrench with a fulcrum length of 30 cm (11.81 In.).

1. 1
   Fill reservoir with brake fluid (see page br- 6)
2. 2
   Bleed air from brake master cylinder (see page br-7)
3. 3
   Bleed air from brake line (see page br-7)
4. 4
   Bleed air from abs and traction actuator assembly (see page br-8)
5. 5
   Check brake fluid level in reservoir (see page br-6)
6. 6
   Check for brake fluid leakage
7. 7
   Install air cleaner case sub-assembly
8. 8
   Install the air cleaner case (see page em-105).

Refer to the procedures from the installation of the air cleaner case up until the installation of the purge vsv.

1. 1
   Connect cable to negative battery terminal
2. 2
   Check abs and traction actuator assembly with intelligent tester
3. 3
   Check the abs and traction actuator with the intelligent tester (see page bc-180).