Brake control

Removal (2005/11-2006/01)

4steps
~29min
2/5difficulty
1special tools
Done 0 of 4
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove air cleaner case sub-assembly
  2. Remove the air cleaner case (see page em-98).
Hint:

Refer to the procedures from the removal of the purge vsv up until the removal of the air cleaner case.

  1. Drain brake fluid
Notice:

Wash off brake fluid immediately if it comes in contact with any painted surface.

  1. Disconnect brake lines
Toyota RAV4. Disconnect brake lines

  1. Using sst, disconnect the 6 brake lines from the actuator.
Sst 09023-00101
  1. Place tags or marks to identify the installation locations of each brake line.

  1. Remove abs and traction actuator assembly with bracket
Toyota RAV4. Remove abs and traction actuator assembly with bracket

  1. Pull the lock lever upward and disconnect the connector.
Toyota RAV4. Remove abs and traction actuator assembly with bracket

  1. Disconnect the brake tube clamp from the bracket.
  2. Remove the 3 nuts and actuator with bracket.
    Toyota RAV4. Remove abs and traction actuator assembly with bracket

Notice:

Be careful not to damage the brake tubes.

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.