Toyota RAV4 Quiz
Lighting

Luggage room light

In this manual: Lighting
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
12steps
~72min
3/5difficulty
Done 0 of 12
Components
Toyota RAV4. Luggage room light

Removal
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove back door center garnish (see page ed-59)
  2. Remove back door side garnish lh (see page ed-59)
  3. Remove back door side garnish rh (see page ed-59)
  4. Remove back door trim board (see page ed- 59)
  5. Remove back door courtesy light assembly
    Toyota RAV4. Remove back door courtesy light assembly

  1. Using a screwdriver, pry out the light as shown in the illustration.
Hint:

Tape the screwdriver tip before use.

Toyota RAV4. Remove back door courtesy light assembly

  1. detach the 4 claws and remove the light shade.
Toyota RAV4. Remove back door courtesy light assembly

  1. Remove the light bulb from the light.
Installation
  1. Install back door courtesy light assembly
Toyota RAV4. Install back door courtesy light assembly

  1. Install the bulb to the light.
Toyota RAV4. Install back door courtesy light assembly

  1. Attach the 4 claws to install the light shade.
  2. Install the light as shown in the illustration.
  3. Install back door trim board (see page ed- 66)
    Toyota RAV4. Install back door trim board (see page ed- 66)

  1. Install back door side garnish rh (see page ed-67)
  2. Install back door side garnish lh (see page ed-67)
  3. Install back door center garnish (see page ed-67)
  4. Connect cable to negative battery terminal

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.