Caution:Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Remove room light lens
Using a screwdriver, detach the 4 claws and remove the lens.
Hint:
Tape the screwdriver tip before use.
Remove room light assembly
Using a screwdriver, detach the 4 claws and remove the 2 covers.
Hint:
Tape the screwdriver tip before use.
Remove the bulb from the room light switch base.
Using a screwdriver, detach the 4 claws and remove the light.
Hint:
Tape the screwdriver tip before use.
Using a screwdriver, detach the 4 claws and remove the room light switch base.
Hint:
Tape the screwdriver tip before use.
Inspection
Inspect room light
Connect the battery's positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, and then check that the light comes on when the switch is in the door position.
Ok: light comes on.
If the result is not as specified, replace the light assembly.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 3, then check that the light comes on when the switch is in the on position.
Ok: light comes on.
If the result is not as specified, replace the light assembly.
Installation
Install room light assembly
Attach the 4 claws to install the room light switch base.
Attach the 4 claws to install the room light.
Install the bulb to the room light switch base.
Attach the 4 claws to install the 2 covers.
Install room light lens
Attach the 4 claws to install the lens.
Connect cable to negative battery terminal
?
Test yourself
A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.
