Toyota RAV4 Quiz
2Az-fe engine mechanical

Removal

In this manual: 2Az-fe engine mechanical
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
23steps
~138min
4/5difficulty
Done 0 of 23
  1. Discharge fuel system pressure (see page fu-9)
  2. Drain coolant (see page co-6)
  3. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove no. 1 Engine cover (see page es-410)
  2. Remove air cleaner cap (see page es-411)
  3. Remove throttle body (see page es-412)
  4. Remove fuel delivery pipe (see page fu-10)
  5. Disconnect fuel tube
  6. Remove heater water inlet hose
  7. Remove the hose clamp.
  8. Remove the heater water inlet hose from the heater radiator unit and cylinder head.
  9. Remove heater water outlet hose
  10. Remove the heater water outlet hose from the heater radiator unit and water by-pass pipe.
  11. Remove intake manifold
  12. Disconnect the union to check valve hose from the brake booster.
  13. Disconnect the camshaft timing oil control valve connector.
  14. Remove the wire harness clamp.
  15. Remove the union to check valve hose from the vacuum hose clamp.
  16. Remove the 5 bolts, 2 nuts and intake manifold.
    Toyota RAV4. Remove intake manifold

  1. Remove the gasket from the intake manifold.
Toyota RAV4. Remove intake manifold

  1. Remove intake manifold insulator
  2. Remove the intake manifold insulator from the cylinder block.
    Toyota RAV4. Remove intake manifold insulator

  1. Remove knock sensor
Toyota RAV4. Remove knock sensor

  1. Disconnect the sensor connector.
  2. Remove the nut and sensor.

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.