Installation

1. Install knock sensor

1. Install the sensor with the nut.

Torque: 20 n*m (205 kgf*cm, 15 ft.*Lbf)

Make sure that the knock sensor is in the correct position.

1. 1
   Connect the sensor connector.
2. 2
   Install intake manifold insulator

   

1. 1
   install the intake manifold insulator onto the cylinder block.
2. 2
   Install intake manifold

   

1. 1
   Install a new gasket into the intake manifold.
2. 2
   Install the intake manifold with the 5 bolts and 2 nuts.

1. 1
   Fit the union to check valve hose into the vacuum hose clamp.
2. 2
   Install the wire harness clamp.
3. 3
   Connect the camshaft timing oil control valve connector.
4. 4
   Connect the union to check valve hose to the brake booster.
5. 5
   Connect heater water outlet hose
6. 6
   Install the heater water outlet hose to the water bypass pipe and heater radiator unit.
7. 7
   Connect heater water inlet hose
8. 8
   Install the heater water inlet hose to the cylinder head and heater radiator unit.
9. 9
   Install the hose clamp.
10. 10
    Install fuel tube
11. 11
    Install fuel delivery pipe (see page fu-13)
12. 12
    Install throttle body (see page es-413)
13. 13
    Install air cleaner cap (see page es-413)
14. 14
    Connect cable to negative battery terminal
15. 15
    Add engine coolant (see page co-6)
16. 16
    Check for engine coolant leakage (see page co-1)
17. 17
    Check for fuel leakage (see page fu-14)
18. 18
    Install no. 1 Engine cover (see page es-414)