Toyota Sienna Quiz
Meter

Entire Combination Meter does not Operate

In this manual: Meter
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

DESCRIPTION

This is the power source circuit to operate the combination meter assembly.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 INSPECT COMBINATION METER ASSEMBLY

INSPECT COMBINATION METER ASSEMBLY
  1. Disconnect the C10 connector.
  2. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance
  1. Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

REPLACE COMBINATION METER ASSEMBLY

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.