Toyota Sienna Quiz
Engine hood / door

Power Slide Door does not Fully Open

In this manual: Engine hood / door
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~2min read

DESCRIPTION

  • When the LH / RH rear window is open 105 mm (5.91 in.) or more, the slide door half-open stopper is activated to force the slide door to stop at approximately 105 mm (5.91 in.) from the fully open position.

    This is caused by the jam protection function between the slide door and vehicle body. A cable connects the rear power window regulator and the slide door half-open stopper directly. When the rear power window regulator operates until the opening reaches 150 mm (5.91 in.) or more, the rear power window regulator transmits a signal to the half-open stopper through the cable and then the stop lever is activated. This prevents the slide door from opening fully.

  • When the power slide door main switch is turned OFF* while the slide door is operating, the slide door stops operation.
* OFF is the position where the orange paint on the top of the switch does not appear
  • Conditions that stop power slide door operation.
    • Power slide door main switch is OFF
    • DTCs B2223 or B2224 set
    • Fuel lid open (only LH side)
    • Touch sensor is open / short
    • With ignition switch ON, shift lever is moved into any position except P position

    INSPECTION PROCEDURE

    1 CHECK REAR WINDOW POSITION

    1. Check that the rear window is fully open or the opening is less than 150 mm (5.91 in.) (the slide door half-open stopper is inactive).

    2 VISUALLY CHECK

    1. Check that there is no foreign object on the sliding area that the door is moving.

    3 CHECK OPERATION

    1. Check that the slide door fully opened by manual operation

    CHECK FOR DTC AND INSPECT POWER SLIDE DOOR SYSTEM

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.