Toyota Tacoma Quiz
Audio / Video

XM Tuner Antenna Disconnected (B15FE,B15FF)

In this manual: Audio / Video
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~2min read
DESCRIPTION

These DTCs are stored when a malfunction occurs in the antenna assembly with holder which is connected to the radio and display receiver assembly.

DTC No.

DTC Detection Condition

Trouble Area

B15FE

The antenna assembly with holder is not connected.
  • Antenna cord sub-assembly
  • No. 2 antenna cord sub-assembly
  • Antenna assembly with holder
  • Stereo component tuner assembly

B15FF

A short occurs in the antenna assembly with holder.
CAUTION / NOTICE / HINT

NOTICE:

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

PROCEDURE

  1. REPLACE ANTENNA CORD SUB-ASSEMBLY

(a) Replace the antenna cord sub-assembly with a known good one and check if the same DTC is output again (See page (1) Clear the DTCs (See page ). ).

(1) Clear the DTCs (See page (2) Recheck for DTCs and check if the same DTC is output again. ).

(2) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

OK

END
NG

  1. REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY

(a) Replace the No. 2 antenna cord sub-assembly with a known good one and check if the same DTC is output again (See page (1) Clear the DTCs (See page ). ).

(1) Clear the DTCs (See page (2) Recheck for DTCs and check if the same DTC is output again. ).

(2) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

OK

END
NG

  1. REPLACE ANTENNA ASSEMBLY WITH HOLDER

(a) Replace the antenna assembly with holder with a known good one and check if the same DTC is output again (See page (1) Clear the DTCs (See page ). ).

(1) Clear the DTCs (See page (2) Recheck for DTCs and check if the same DTC is output again. ).

(2) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

OK

END
NG

REPLACE STEREO COMPONENT TUNER ASSEMBLY

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.