Steering
ECU Power Source Circuit Malfunction (B2620)
DESCRIPTION
The ECU power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.
DTC Code | Detection Condition | Trouble Area |
B2620 |
The voltage of the ECU power source drops to 8 V or less and this condition continues for 10 seconds or more. |
- ECU-DCC NO. 2 fuse
- Harness or connector
- Multiplex tilt and telescopic ECU
|
WIRING DIAGRAM
HINT:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)
(a) Disconnect the J174 multiplex tilt and telescopic ECU connector. |
 |
*a |
Front view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
|
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
J174-9 (ECUB) - Body ground |
Always |
11 to 14 V |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)
(a) Disconnect the J174 multiplex tilt and telescopic ECU connector. |
 |
*a |
Front view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
J174-8 (GND2) - Body ground |
Always |
Below 1 Ω |
| OK |
 |
REPLACE MULTIPLEX TILT AND TELESCOPIC ECU |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?